Precision stamping parts quality and precision is to a large extent will depend on the mold,
so if mold examination process is no problem, precision stamping parts to meet the standards.
But we must not forget in precision stamping parts production process, also taking into account safety issues.
Of course refers to the safety issues for precision stamping dies, first structural
design should as far as possible
ensure that feed, materials, parts, easy to clean up waste. And for large precision stamping when, if I had
to make the operators ' hands into the die job, may reduce the scope for input, as well as short as possible
time a part of the body in mold, also equipped with the necessary protective
measures and devices as possible.
In time of small precision stamping parts, already without any part of the body close to the work area, so more
is to prohibit such practices. When stamping mold disassembly should be convenient and safe, avoiding the
possibility of finger, hand-cut, reducing unnecessary harm.
In addition, not allowed to occur in the processing of precision stamping process waste or workpiece missiles
because it will affect the operator's attention, even injuring the operator. But too many and difficult movements
are not allowed in the press when, to avoid harm.
Requirements for precision stamping dies for all kinds of parts, shall have sufficient strength and rigidity to
prevent damage and deformation in the process, particularly those fasteners against loosening of the measures to
prevent the operator. All in all, even minor problems will affect security, so be careful.
- DC Circuit Breaker Arc-quenching Pr...
- Selection Of DC Contactor
- Contactors For The Regular Maintena...
- Molded Case Circuit Breakers Work
- What Are The Characteristics Of AG ...
- Rotary Switch Features
- The Normal Operation Of AC Contactor
- Classification And Use Of Buttons
- Connector Features Many
- Single-row Stitch Design Advanced
- About AOKAI
- Introduction Of Kingdee Software
- High Voltage DC Contactors
- The Reason And The Handling Method ...
- The Reasons Of The Contact Resistan...
- The Handling Method Of The Contact ...
- The Characteristic Of DC Contactor ...